Test Management
Environment (TME) for Release 1.323 Full Patch from 1.32 for
882CA
Using TME
Download to PC.
Unzip the contents and put them on top of the existing
1.32 installation.
To run the TME, Double-click TME.jar
To manually run the TME through a command-line Java runtime, enter:
java -jar TME.jar
from the TME's main folder.
Notes:The TME is run through any platform that can run executable Java JAR files. For Windows machines, this will be set up for you upon installation of the Java Runtime Environment (JRE). The TME will be displayed shortly after. The TME requires a resolution of 800x600 or higher.
The TME requires Java Run Time Environment (JRE) 1.5 or later.
The TME requires Firmware 20.1884202 or later (20.1884202 is the vxWorks firmware file for Release 2.8.2).The TME requires CEC and TME options on the 882CA generator. View GenStats image, verify -CEC and -TME options are shown. If not, contact Quantum Data for information on upgrading.
Test modifications only apply to new devices. You
can use the same CDFs that you have been using with the
previous TME version, but you need to make a new Unit:Device
object to rebuild them using the TME 1.323 system.
If you have the TPA-MP-4R instead of TPA-CEC-4R, then make sure to disable EDID Formats and Emulate modes. You can press Sink -> Options to check if they are enabled or not.
Anomalies corrected
The following is a list of anomalies corrected as part of this patch.
Fixed 11.1.13-5 appearance issue.
Fixed 9.6-2 showing up when no HDMI outputs exist.
Fixed minor step order issue with some DUTs.
Fixed CECT12 issue where the TE fails the DUT because of its polling messages.
The 11.2.9-2 test will now allow the logical address to be detected when the EDID is modified.
Other Release Notes
You can obtain Release Notes for past releases as follows:
